Detectors 068
Detectors 068 : Particle Detectors: (5) Non-Acoustic Detection: Visual observation is the obvious means of detecting bats, but of course this can only be done in daylight or crepuscular conditions. (dusk and dawn). Emergence counts are done visually at dusk, using a bat detector for confirmation of species. In lower light conditions a night vision device can be used but the more affordable generation 1 type has a lag time which fails to provide a suitable image of a flying bat. Infrared (IR) cameras and camcorders are used with an IR illuminator to observe bat emergences and bat behaviour inside and outside roosts. The problem with this method is that deriving a count from a recording is tedious and time consuming, but camcorders can be useful as a backup in roost emergence counts to observe bats re-entering the roost. Many Sony camcorders are sensitive to infrared. Infrared beam devices usually consist of a dual array of invisible IR beams. The size of the roost entrance determines the number of beams necessary and thus the power required and potential for off-mains use. Single beam DIY systems are available for bat boxes but these do not log the direction of transit. Almost all the systems in use today are non-commercial or DIY. A system in use in some mines in Wisconsin uses two arrays of beams however they are spaced quite far apart and consequently only log approximately 50% of the bats although extrapolated figures are achieved through correlation of time stamped video and beam break data. The Countryside Council for Wales (CCW) uses two similar systems with beams spaced close enough together that every bat transiting the entrance is logged along with the temperature. These systems require either mains power or 12 V deep cycle batteries. They can be used in conjunction with an Anabat Zcaim installed in a 6" soil pipe and pointed across the roost entrance to discriminate between species by correlating the time stamp data from the IR array and filtered Anabat Zcaim data for horsehoe bats (relatively easy due to their easily identifiable CF echolocation which can be filtered automatically using Anabat software)
No records Found